Document Basket

Saved pages

Saved documents

Please note: This information is saved in a cookie. In case your browser deletes cookies after a session, the information will be lost.

Need support?

Please leave a message

×
Thank you for your message. A representative will get in touch with you shortly.
Seta - Oil Test Centrifuge - 4 place Centrifuge

This purpose-made Oil Test Centrifuge is fully programmable allowing automatic configuration to the specified oil test parameters. A four place swing out rotor and universal bucket assembly accommodates low cost adaptors and cushions suitable for borosilicate glass centrifuge tubes of the types specified for oil testing: 6 or 8 inch conical, 8 inch trace sediment, 8 inch pear-shaped or 12.5ml. To reduce errors in measurement of tube content, the rotor design allows tubes to stand in a near upright (vertical) position at rest.

Technical specifications

Maximum Relative Centrifugal Force (RCF) 2214g
Maximum Rotational Speed 3000 rev/min
Temperature Range 30 to 80°C ±1°C at 60°C
Timer Range 10 seconds to 59 minutes 50 seconds (10 second steps) up to 1 hour run time. After 1 hour run time the centrifuge run time is 1 hour to 99 hours 59 minutes (only 1 minute steps are possible). Continuous running until manually stopped
Control Microprocessor with 99 memory capacity
Capacity 4 Samples
Voltage range 220/240V, 50/60Hz (Optional transformer for 110/120V)
Power 950W
Dimensions (H x W x D) / Weight 40.1 x 56.41 x 63.93cm 72.5kg

Key features

  • Conforms to safety requirements IEC 1010-1; 1010-2-D
  • 4 place swing out rotor
  • Static, near vertical bucket positioning
  • Specifically designed for testing oils
  • Heated chamber, ambient to 80°C
  • Membrane ‘touch’ control panel
  • Pre-heat facility to ensure bowl is at test temperature prior to test
  • Universal buckets for 12.5ml, 6 and 8 inch glassware
  • Optional ‘Setafuge’ Hazard Reduction System
  • Microprocessor control with 99 memories
  • Optional trolley
  • Environmental
  • Oil & Gas
  • Pharmaceutical
Stanhope-SetaStanhope-Seta design and manufacture quality control instruments used to measure the physical characteristics that determine product quality and consistency. The 'Seta' range includes test equipment for the hydrocarbons industry as well as many other laboratory test applications for quality control, calibration and analysis.
[]